What type of metal(s) and alloy(s) will be pumped? (example: Aluminum, Zinc, A356, etc.)

What is the furnace capacity for molten metal (Lbs. or Kgs.)?

Is there a pump well presently on the furnace? If so, what are the dimensions (inch x inch (cm x cm))?

What is the minimum metal depth the pump will operate in the furnace (inches or cm)?

What is the maximum metal depth the pump will operate in the furnace (inches or cm)?

What is the dimension from the top of the sill to the bottom (floor) of the well (inches or cm)?

Do you presently use gas injection (or do you plan to)? If so, what gas do you inject?

If so, how is gas injected now? What rate is it injected (SCFH or lbs./hr)?

What are the dimensions of the charge well (inch x inch (cm x cm))?

At what rate is the material (scrap) charged (Lbs. or Kgs. Per hour)?

What type of scrap is charged? How is it charged - continuous (vibratory feeder, etc.) or batch charged (front end loader, etc.)?

What is the size of smallest and largest pieces (in lbs.) of scrap charged into the well?

Are you presently using a pump now? If so, please provide manufacturer, model, length, air or electric driven, and any additional information that might be helpful.