What type of metal(s) and alloy(s) will be degassed? (example: Aluminum, A356, etc.)

What type of degassing application is this - continuous (in-line) or batch (ladle, crucibles, etc.)?

What is the incoming hydrogen level (or metal density)?

What is the required outgoing hydrogen level (or metal density)?

What is the theoretical maximum density of this material?

Continuous: How many spinning shafts are being used?

Continuous: What are the dimensions of the degassing well (length x width x total depth)?

Continuous: What is the normal metal depth?

Continuous: How much metal is in the degassing well (lbs. or kgs.)?

Continuous: What is the flow rate of metal through the system?

Continuous: What type of gas is being injected (argon, nitrogen, chlorine, a mix, etc.)?

Batch: What is the diameter and depth of the crucible or ladle?

Batch: What is the metal depth of the crucible or ladle?

Batch: How much metal does the ladle or crucible hold (lbs. or kgs.)?

Batch: How long is the degassing treatment cycle (minutes)?

Continuous or Batch: What type of gas is being injected (argon, nitrogen, chlorine, a mix, etc.)?

Continuous or Batch: What is the flow rate of injected gas?

Continuous or Batch: Whose shaft & rotor design are presently being used?

Continuous or Batch: What is the size of the rotor (diameter and height)?

Continuous or Batch: What is the diameter of the shaft?

Continuous or Batch: What is the overall length of the shaft & rotor assembled?

Continuous or Batch: Does the shaft have a protective sleeve on it? If so, how long and where is it located?

Continuous or Batch: What is the thread connection at the top of the shaft? If  possible, please send a drawing.

Continuous or Batch: How fast does the shaft & rotor spin (RPM)?

Continuous or Batch: Does the shaft & rotor spin clockwise (RH) or counter-clockwise (LH)?

Continuous or Batch: Is flux injected? If so, please specify type and how much is injected?